Haier HWM130-9188 User Manual - Page 18

After washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean the detergent box and set it on the control panel seat. 1.The method of dismantle: Push it up aslant and gently. 2.The method of install : install it upwards and aslant and push it in . The lint filter must be used during washing. It must be cleaned in time after each using. Lint filter: 1.Push down the spring piece of the top lint filter to make the claws out of the filter cover, and then pull out the lint filter to get it down. figure1 2.Pull the back of the lint filter, and then you can get down it off the front cover of the lint filter. figure2 3.Sweep the rubbish in the lint filter. 4.Put the back of the lint filter into the front cover . 5.Put the lint filter into filter cover, and make it tight . 6.Make sure the lint filter well installed, or it can influence your use. Dismantle Install Install Figure 1 The back cover of lint filter Up Dismantle Dismantle Up Install Down Down The front cover of lint filter Figure 2 The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it with brush every two months. If the cabinet is dirty, wipe it with wet cloth Do not flush it directly with water. Wipe it with neutral detergent. Do not wipe it with thinner, petrol, alcohol etc. Petrol Thinner Alcohol 1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose). 2.Do not store water in the washing machine for a long period. Drain the water completely after each using. 3.Be sure to pull off the power plug before maintenance. 4.Hang up the power cord and drain hose. 5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (about 1 hour), then close the top lid. 16