Haier HWM60-78 User Manual - Page 5
Installation and adjustment, Close the lid, Finish washing
View all Haier HWM60-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Using process * Total time: including the normal water inlet time and drain time. The total washing time may be influenced by the water inlet pressure and water level. * Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the time remain digitron is the total remaining time) * In soaking, after water inlet it will perform soaking for about 10-40 minutes, then perform washing, rinsing and spinning. * In selecting "POSTHASTE" program, the washing machine will set the complete procedures of water level selectior, washing, rinsing and spinning automatically. Push the "RESERVE" button to select suitable reserve wash program RESERVE After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing procedure to be finished at reserved time, please push the " RESERVE " button to set the reserve wash program. Refer to reserve button in Page 11 for selection Confirm the operation of reserve program Page When the "RESERVE" function is activated, the indicator light of the program you have set will be off. During reserve procedure, push the "RESERVE" button to display the reserve mode. To change the running program or cancel the reserve setting, you the washing will be finished after 18 hours. need to switch off the power and make new selection. Push the "START/PAUSE" button 5 Close the lid START PAUSE 6 Finish washing After the top lid opened,the washer will automatically give an alarm and stop running,exclusively during supplying water of fuzzy program and draining. After finishing wash,it will alarm automatically. Installation and adjustment Before Using Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine. Install the inner cover component Before using the washing machine firstly, please install the inner cover component. 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, aiming the inner cover shaft to the installation hole of the corresponding outer tub cover shaft groove. 3.Firstly insert the inner cover shaft of the left side into the corresponding outer tub cover shaft groove(see to the figure 1), then hold the middle position of the front of the outer tub cover with left hand forcibly , handhold the right and below position of the inner cover with right hand, push the inner cover to the outer cover vertically, make the inner cover shaft into the corresponding outer tub cover shaft groove(see to the figure 2). Please install to designated position to guarantee there are no dropping or abnormal sound in opening and closing of the inner cover, and the operation shall be smooth. Do not dismount the inner cover component after washing. Right hand Outer tub cover Figure 1 Outer tub cover shaft groove Inner cover shaft Inner cover Figure 2 Left hand Note:the two damping mats of outer tub cover should not fall off, otherwise the inner cover maybe librate during spinning Install the bottom plate After opening the package, please lean the washing machine gently down on soft items (like towel cloth,blanket, etc.). Install the bottom plate to the bottom of the machine with eight screws by a cross screwdriver, then lift the machine up gently. See to the figure: Front Back Bottom plate Screw Soft object