Haier HWM60-78 User Manual - Page 7
Confirm the water faucet, Connection between the water inlet hose jointer and the water faucet
View all Haier HWM60-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Using process Steps of using the operation buttons and description of the steps XQS60-78 Minutes Minutes SOAK WASH Times RISE Minutes Time remained (minutes) 9 7 5 3 Reserve 1 (hours later) SPIN RESERVE NORMAL 10 8 6 FIBRE COTTON WOOLLEN QPUOICSKTHASTE JEAN 4 SILK 2 WATER LEVEL PROGRAM START PAUSE POWER ON/OFF Push the "POWER ON/OFF " button to switch on the power. POWER ON/OFF 2 Push the "PROGRAM" button to select suitable automatic program. PROGRAM After switching on the power, the machine will set "NORMAL" program automatically. To select other automatic program, push the "PROGRAM" button till the relative indicator is on. Refer to the "PROGRAM " on Page 11 for the selection. For instance: select "POSTHASTE"program for laundries with small Page 11 quantity and light soil. In selecting the "NORMAL" program, the machine will execute fuzzy program to select water and wash time according to the cloth and weight of the laundries. The full procedure is controlled automatically. FIBRE COTTON WOOLLEN SILK NORMAL QUICK POSTHASTE JEAN Push the "SOAK", "WASH", "RINSE" or "SPIN" button to select suitable procedure. Minutes Minutes Times Minutes SOAK WASH RINSE SPIN Install the water inlet hose Before Using Confirm the water faucet water faucet, suitable The exit end face of the faucet water faucet, not suitable It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to Figure 3.) water inlet hose jointer Slider Screw Lock lever Screw knife Sign plate water inlet hose Figure 1 Figure 2 3.Fasten the four screws evenly. See to Figure 4. 4 Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5. remark: Before installation, the threading is 4mm above the upper surface of the nut. After installation, the threading is 2mm above the upper surface of the nut.. Bushing Figure 3 Figure 4 Figure 5 Screw nut About 4mm before twisting About less than 2mm after twisting Figure 6