Haier HWM65-918P User Manual - Page 14

Trouble-shooting · Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomenon are not breakdowns sometimes. Please con¿rm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena The reason How to settle The digitron displays E0. The drainage cannot work, or is too slow. The digitron displays E1. The top lid is open during reserve procedure. Is the drain hose blocked? z Close the top lid. z Clean the foreign material. Open and close the top lid once. It stops running in midway. The digitron displays E2. The safety switch acts, and the spinning cannot work. The digitron displays E3. The water ¿lling does not work, or is slow, the digitron displays E4. The digitron displays E6. The digitron displays F2. The machine does not act Not wash Not spin There is abnormal sound inside the machine The water tap leaks The top lid is not closed. z Close the top lid. When using the child lock function, if the top cover is opened, the machine will stop and display E2 z Clear the E2 alarm, please close the top cover and press the "START/PAUSE" button. Then E2 alarm will be cleared. alarm. After 15 seconds the machine will automatic drainage Are the laundries put slantingly? Is the machine slanting? z Reorder the laundries. Close the top lid. z Place the machine horizontally, open and close the top lid once. Is the water tap opened, or is there water supply failure? Is the water inlet valve blocked? Is the water pressure too low? z Open the water tap. Open and close the top lid once. z Clean the water inlet valve then open and close the top lid once. z Use after the water pressure is normal. The water level sensor is bad. Overflow alarm Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? z Please contact the after-sales service department. Please contact the after-sales service department. z Please use it when there's power supply. z Insert the power plug tightly. z Fill water to the preset position. Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set Àat? Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? Is the screw of the jointer of water inlet hose loose or awry? z Insert the power plug tightly. z Close the top lid. z Set the laundries Àat. z Adjust the machine to be even z Reorder the laundries and close the top lid. z Remove the foreign materials. z Fasten the screw of the jointer properly.