Haier HWM65-918P User Manual - Page 6

Installation and adjustment Please install and adjust the machine according to the requirement of the mannual. It is very important to your security and correct operating the machine. Install the bottom plate Insert the bottom plate to the pedestal from the front to the back and the two fasteners to the opposite holes, then install the bottom plate to the pedestal with the screw Front by a cross screwdriver . See to the figure : (Please first pull off the power plug from the receptacle Back before installing.) Screw Two fasteners Carpet Bottom plate Adjust the Installation position The washing machine away from wall should be overrun 20mm. The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods: Confirm it's horizontal Hang the lead line to check if it is horizontal. Adjust the adjustable leg: Please lift up the side of the leg slightly, twist the adjustable leg, make sure to keep the washing machine in balance. Usage of the drain hose Hang the drain hose to a suitable height. The drain hose shall be higher than the water in the tub avoid to siphon.(It doesn't work normal as inleting water as drain) High Low Adjustable H 0.7m