Haier HWM80-FD756DD User Manual - Page 11

20 Troubleshooting Display code Code Cause Solution Auto Automatic load detection. AL-1 /AL-2 /AL-3 /AL-4 Weighing the laundry load in the drum. Laundry weight detection in progress, please wait until program cycle time is displayed. Please wait until program cycle time is displayed: AL-1 = small load;AL-2 = half load; AL-3 = optimized weight load; AL-4 = full load. 1:25 Remaining wash cycle time. Refer to additional symbol. 19:30 Lock End E1 E2 E4 E8 F3 Remaining wash cycle time. End is likely delayed - refer to symbol. Door cannot be opened due to water level or hot water in the drum. Wait to the end of program or cancel the program and select the drain program. In case of hot water is in the drum, to avoid scalding, select a handwash program and wash several minutes and then select a draining program before open the door. End of cycle. Drainage error, water not emptied Clean pump filter. within 6 minutes. Check drain hose for blockage and proper installation. Lock - error. Water level not reached after 8 minutes. Shut the door properly. Check if water supply and water pressure is normal. Drain hose is self-syphoning. Water protective level - error. Auto release.Otherwise contact the After sales service. Temperature sensor - error. Contact the After sales service. F4 Heating error (Appears at the end of Contact theAfter sales service. a cycle). F7 Motor - error. Contact theAfter sales service. FA Water level sensor error. Contact theAfter sales service. FC Electronic control - error. Contact theAfter sales service. Unb Unbalanced load and not able to Check and balance the laundry load in the spin. drum. Also reduce the load if too heavy. Restart with a spin program. Troubleshooting 21 In case of power failure lever The current programme and its setting will be saved only for a short time. Probably a new programme cycle start is needed. If a power failure cuts an operating wash programme door opening is mechanically blocked.To get out any laundry water level should not be seen in the glassy porthole of the door - danger of burns! Not till then pull lever beneath service flap until door is unlocked by a gentle click.Afterwards refix all parts. Troubleshooting without display code Problem Cause Solution Washing machine fails to operate. Programme is not yet started. Press "Start/Pause" button. Door is not properly closed. Close the door properly. Machine has not been switched on. Switch the machine on. Power failure. Check power supply. Washing machine will not be filled with water. No chosen programme. No water. Inlet hose is kniked. Inlet hose filter is blocked. Water pressure is less than 0,03 MPa. Water supply failure. Set programme and start it. Check water tap. Check inlet hose. Unblock inlet hose filter. Check water pressure. Ensure the water supply. Machine is draining while being filled Height of drain hose is below 80 cm. Drain hose end could reach into water. Make sure that drain hose is properly installed.