Haier L42R3 User Manual - Page 17
Quick Menu, USB MODE
View all Haier L42R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Vertical Pos.: Vertical position of picture can be adjusted in this item. Clock: This is used for adjusting H Position and V Position as well as relative parameters in PC modes. Phase : This is used for adjusting the phase of pixel clock in PC mode. Quick Menu This function includes some usual oprations about PICTURE,SOUND,SAP,SLEEP TIME,Aspect Ratio and BACKLIGHT. Q.MENU PICTURE Standard SOUND Standard SAP Mono SLEEP Off ASPECT RATIO Full Screen BACKLIGHT 100 Close USB MODE Note R The diagrams in the following section are schematic and only for your reference. Please see the actual product if necessary. TO USE THE USB DEVICE Supported file formats: • Photo: *.jpg,*.bmp, ect; • Music: *.mp3,*.wma, ect; • Movie: *.AVI,*.mpg,*.DAT,*.TS,*.MOV,*.mp4,*.VOB; • TEXT: *.txt Note R Due to the particularity of file coding, some files Operation may be unable to read. R The USB Movie player can surpport codes as MPEG2, MPEG2_HD,MPEG4,MPEG4_HD,H.264. when its coding doesn't include in the codes upwards. Supported equipment: Support the equipment that supports Mass Storage Protocol and whose file system is FAT32, such as some USB disks and mobile harddisks. If USB equipment could not be identified due to unsupported file system, please format the equipment to the above-mentioned file system. To achieve smooth playing, ensure the following: • The file code rate should be lower than 300KB/S; • Due to the limitation of USB signal transmission distance, it is recommended not to use USB patch cord, in case of using the cord, make sure that its length is not over 1m; • Use high-speed USB equipment in conformity with USB2.0 full speed Interface Standard; If USB equipment in conformity with USB1.1 full speed Interface Standard is used, the playing may be unsmooth. When connecting/removing the USB device Press INPUT on the remote control unit to select USB option. Insert USB equipment into corresponding USB interface 2s after starting the system. After entering the system menu, press /on the remote control unit to select the require USB files, press OK button to confirm the selection and enter the file list relative to the selection. Press /on the remote control unit to select the required file, press ENTER button to enter the selected file. To exit the streaming media playing system and watch a TV program, you must press EXIT button to return to the streaming media main menu at first (to protect equipment), and then press INPUT to select AIR or Cable to return to the TV mode. Note TV LCD-TFT Owner's Manual EN-16