Haier L42R3 User Manual - Page 9

How to connect A Connect the DVD video outputs (COMPONENT) to the Y Pb Pr jacks on the TV and connect the DVD audio outputs to the YPbPr Audio IN jacks on the TV, as shown in the figure. B If your DVD only has an S-VIDEO output jack, connect this to the S-VIDEO input on the TV, as shown in the figure. or DVD Note R If your DVD player does not have component video output, use S-Video. How to use A Turn on the DVD player, insert a DVD disc. B Use INPUT button on the remote control to select component mode. C Press PLAY button on external equipment for program play. D Refer to the DVD player's manual for operating instructions. Q Component Input ports To get better picture quality, connect a DVD player to Installation the component input ports as shown below. Component ports on the TV Y Pb Pr Video output ports on DVD player Y Pb Pr Y B-Y R-Y Y Cb Cr Y PB PR Connecting a DTV (digital TV) This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). How to connect q Use the TV's COMPONENT, VGA or HDMI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use A Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box.) B Use INPUT on the remote control to select COMPONENT, VGA or HDMI source. Signal 480i 480p 720p 1080i 1080p COMPONENT Yes Yes Yes Yes Yes HDMI Yes Yes Yes Yes Yes Connecting a digital audio output Send the TV's audio to external audio equipment (stereo system) via the Digital Audio Output (Optical) port. How to connect A Connect one end of an optical cable to the TV Digital TV LCD-TFT Owner's Manual EN-8