Hannspree HT09 User Manual - Page 38

English 28US_LCDTV.book Page 38 Thursday, July 3, 2008 5:33 PM 5. During the setting process, releasing the electronic equipment button exits the setting mode immediately without changing the status prior to setting. 6. During the setting process, only digit keys '0' through '9' are valid inputs, while other buttons are deemed invalid and do not affect the code setting. For example, inputting "02" then pressing RETURN does affect the "02" already input. 6.1.3 Searching Codes If the desired electronic equipment code for setting can not be found on the list in the appendix, try to use the code-searching function with operating procedures as follows: 1. Press the corresponding electronic equipment button. The indicator light will come on for 200ms and then go off; after 3 seconds, the indicator light will come on again, showing that the setting mode has been entered. 2. Hold the electronic equipment button while pressing POWER, then input mode codes 9-9-9 in sequence. If the indicator light does not come on again after going off, the code setting is valid; otherwise the indicator light comes on again after going off for 600ms, prompting user to re-enter mode codes. 3. If setting is successful, the electronic equipment code-searching state is entered upon releasing the electronic equipment button. The POWER signal of all manufacturers' codes under the current electronic equipment mode is then transmitted automatically every 5s. 4. During search, the indicator light will flash when the POWER signal of each electronic equipment is transmitted. When one cycle of code-searching is complete, the indicator light will come on for 600ms before going off, exiting search mode automatically. 5. Pressing CH+/CH- during search transmits the next/previous electronic equipment POWER signal without waiting for 5s, and resets the timer to trigger another 5s interval. 6. Pressing POWER during search exits search mode without saving the new electronic equipment code; pressing OK during search saves the most recently searched electronic equipment code and then exits search mode. 7. Buttons other than POWER, OK, and CH+/CH- are not functional during search. 38