Harbor Freight Tools 62365 User Manual - Page 13

Stopping the Engine

Get Harbor Freight Tools 62365 - Towable Ride-On Trencher PDF manuals and user guides View all Harbor Freight Tools 62365 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Safety 6. Slide the Throttle or Speed Control Lever to 1/3 away from the SLOW position (the "turtle"). Adjust as needed. Note: Some tools have a Speed Control Lever located elsewhere on the tool which functions the same as the Throttle. Use the Speed Control Lever in place 6 of the Throttle when the tool is so equipped. IMPORTANT: Allow the engine to run at no load for five minutes after each start‑up so that the engine can stabilize. Break-in Period: a. Breaking-in the engine will help to ensure proper equipment and engine operation. b. The operational break-in period will last about 3 hours of use. During this period: • Do not apply a heavy load to the equipment. • Do not operate the engine at its maximum speed. c. The maintenance break-in period will last about 20 hours of use. • Change the engine oil after this period. Under normal operating conditions subsequent maintenance follows the schedule explained in the Maintenance section. Stopping the Engine 1. To stop the engine in an emergency, turn the Engine Switch off. OFF O I 2. Under normal conditions, use the following procedure: a. Turn the Engine Switch off. b. Close the Fuel Valve. Setup Operation Maintenance NOTICE See "Long-Term Storage" on page 15for complete storage instructions. Item 62365 For technical questions, please call 1-888-866-5797. Page 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Page 13
For technical questions, please call 1-888-866-5797.
Item 62365
SAFETY
SETUP
OPERATION
MAINTENANCE
Stopping the Engine
1.
To stop the engine in an emergency,
turn the Engine Switch off.
2.
Under normal conditions, use the following procedure:
a. Turn the Engine Switch off.
b. Close the Fuel Valve.
NOTICE
See “Long-Term Storage” on page 15 for complete storage instructions.
O
I
OFF
6.
Slide the Throttle or Speed Control Lever to 1/3 away
from the SLOW position (the “turtle”). Adjust as needed.
Note:
Some tools have a Speed Control Lever located
elsewhere on the tool which functions the same as
the Throttle. Use the Speed Control Lever in place
of the Throttle when the tool is so equipped.
IMPORTANT:
Allow the engine to run at no load for five minutes
after each start-up so that the engine can stabilize.
Break-in Period:
a. Breaking-in the engine will help to ensure proper equipment and engine operation.
b. The operational break-in period will last about 3 hours of use.
During this period:
• Do not apply a heavy load to the equipment.
• Do not operate the engine at its maximum speed.
c. The maintenance break-in period will last about 20 hours of use.
• Change the engine oil after this period.
Under normal operating conditions subsequent maintenance follows
the schedule explained in the MAINTENANCE section.
6