HealthRider H15x Bike Enc Manual - Page 7

3. If there is a cardboard tube (not shown) on the front the Frame (1), remove and discard the 3 attachment screw and the cardboard tube. Set a sturdy piece of packing material under the front of the Frame (1). Have a second person hold the Frame to prevent it from tipping while you complete this step. Attach the Front Stabilizer (9) to the Frame (1) with two M8 x 92mm Screws (50) and two M8 Curved Washers (51). Remove the packing material. 50 9 51 1 4. While a second person holds the Upright (3) near the Frame (1), connect the Extension Wire (38) to the Reed Switch Wire (26). Next, connect the Resistance Cable (24) to the Lower Resistance Cable (27) in the following way: • See drawing A. Pull upward on the metal bracket on the Lower Resistance Cable (27), and insert the tip of the Resistance Cable (24) into the wire clip inside the metal bracket. • See drawing B. Firmly pull the Resistance Cable (24) upward and slide it into the top of the metal bracket. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. Insert the wires and cables into the Frame (1). Tip: Avoid pinching the wires and cables. Slide the Upright (3) onto the Frame (1). Attach the Upright with four M8 x 20mm Screws (52) and four M8 Curved Washers (51); start all the Screws, and then tighten them. 4 Avoid pinching the wires and cables 3 51 52 38 26 51 52 24 27 1 A B C Metal Bracket 24 24 27 7