HP 4300n HP LaserJet 4200 and 4300 series printer - User Guide - Page 127
Light print partial Specks, TONER DENSITY
UPC - 808736314381
View all HP 4300n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
See "Scattered lines" on page 130. See "Blurred print" on page 130. Light print (partial page) 1 Make sure that the print cartridge is fully installed. 2 The toner level in the print cartridge might be low. Replace the print cartridge. 3 Maintenance might be due. Check this by printing a copy of the supplies status page. (See "Supplies status page" on page 85). If maintenance is due, order and install the printer maintenance kit. (See "Performing preventative maintenance" on page 91.) Light print (entire page) 1 Make sure that the print cartridge is fully installed. 2 Make sure that the EconoMode setting is turned off at the control panel and in the printer driver. (See "ECONOMODE" on page 161.) 3 Open the Configure Device menu at the printer control panel. Open the Print Quality submenu and increase the TONER DENSITY setting. (See "TONER DENSITY" on page 161.) 4 Try using a different type of paper. 5 The print cartridge might be almost empty. Replace the print cartridge. Specks Specks might appear on a page after a jam has been cleared. 1 Print a few more pages to see if the problem corrects itself. 2 Clean the inside of the printer and run a manual cleaning page to clean the fuser. (See "Cleaning the printer" on page 87 and "Running the cleaning page manually" on page 89.) If specks occur frequently, you can set the printer to run a cleaning page automatically, if the printer does not have an optional duplexer installed. (See "Running the cleaning page automatically" on page 90.) 3 Try using a different type of paper. 4 Check the print cartridge for leaks. If the print cartridge is leaking, replace it. ENWW Correcting print-quality problems 125