HP 8/24 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Apri - Page 577
addresses are not supported. This operand is required with
View all HP 8/24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 577 highlights
portCfg 2 -r value -s value -t value -z value Specifies the number of records. The range is 0 to 1,677,721. The default is 200000. Specifies the trigger mask value. The range is 00000000 to FFFFFFFF. The default is 00000003. Specifies the trace mask value. The range is 00000000 to FFFFFFFF. The default is 80000C7B. Specifies the trace record size in bytes. The range is 80 to 240 bytes. The default is 80 bytes. inbandmgmt Configures IP addresses and routes for the CP or GbE port inband management interfaces on the Brocade 7500. Inband management allows a management station to communicate with the CP through GbE ports. The command syntax for portCfg inbandmgmt is as follows: portCfg inbandmgmt ge_port option arguments ipaddrset cp | ge ip_address netmask Configures the IP address and netmask for a CP or a GbE inband management interface. This command requires specifying the type of interface (cp or ge), an IPv4 address, and the subnet mask. For each management interface, configure two IP addresses, one for the CP and one for the GbE port. ipaddrdel cp | ge ip_address Deletes the IP address for a CP or GE inband management interface. Specify the type of interface (cp or ge) and the IPv4 address to be deleted. cp | ge Specifies the interface type as either CP or port processor. This operand is required when configuring or deleting an IP address. ip_address Specifies the IP Address for the inband management interface. The IP address must be in IPv4 format, followed by the subnet mask. IPv6 addresses are not supported. This operand is required with the ipaddrset and ipaddrdel options. netmask Specifies the subnet mask for the IP address in a.b.c.d format. This operand is required only with the ipaddrset option. routeadd destination netmask [gateway] Adds a route to the management station for an existing CP or GbE port (CP or GbE designation is made automatically). You must specify the destination IP address and the subnet mask when adding a management route. You must create the IP addresses for the CP and the GbE port interfaces before you can add a route to the routing table. Use portshow iproute to display existing routes. Use portshow inbandmgmt to display the management interface status and IP addresses. routedel destination netmask Deletes a management route from an internal CP or a GbE port interface. You must specify the destination and the subnet mask when deleting a management route. Fabric OS Command Reference 549 53-1001186-01