HP 8/24 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Apri - Page 86
bpTurboRamTest, Processor BP ASICs of the Application Processor AP Blade. The command makes use of
View all HP 8/24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
2 bpTurboRamTest bpTurboRamTest Synopsis bpTurboRamTest - MBIST test for AP Blade BP ASICs. bpturboramtest [ -passcnt count ] [ -bpports itemlist ] Description Use this command to verify the on-chip static random access memory (SRAM) located in the Blade Processor (BP) ASICs of the Application Processor (AP) Blade. The command makes use of the memory built-in self-test (MBIST) circuitry. The test flow for each SRAM is as follows: 1. Fill RAM with alternating FFFF 0000 pattern. (Subtest 1: turboram memory fill) 2. For each incrementing address read FFFF 0000 pattern and write 0000 FFFF. (Subtest 2: turboram r-m-w inc 1) 3. For each incrementing address read 0000 FFFF pattern and write FFFF 0000. (Subtest 3: turboram r-m-w inc 2) 4. For each decrementing address read FFFF 0000 pattern and write 0000 FFFF. (Subtest 4: turboram r-m-w dec 1) 5. For each decrementing address read 0000 FFFF pattern and write FFFF 0000. (Subtest 5: turboram r-m-w dec 2) 6. Repeat steps 1-5 with AAAA 5555 pattern. Notes This command is currently supported only on the Brocade Encryption platform. It complements the turboramTest, which tests the Condor2 ASIC on the switch. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: -passcnt count Specifies the number of test repetitions. By default the test runs once. -bpports itemlist Specifies a list of blade ports to test. By default all blade ports in the specified blade are tested. Note that on the Encryption platform, ports 80-103 are the blade ports connected to the BP ASICs. Refer to the itemlist help page for further information on the itemlist parameter. Example To run the test in default mode: switch:admin> bpturboramtest Running bpturboramtest Board Init Running Vader bist test Vader bist test PASSED Running Ob1 bist test Ob1 bist test PASSED BIST test PASSED on all ASIC(s) Test Complete: bpturboramtest Pass 1 of 1 Duration 0 hr, 1 min & 55 sec (0:1:55:884). Cleaning up after test....... passed. SEE ALSO turboramtest 58 Fabric OS Command Reference 53-1001186-01