HP 8550 Service Manual - Page 16

Figure 361. Sensor flag and connector 429 Figure 362. Delivery roller mount 429 Figure 363. Delivery roller and stamp solenoid mount 429 Figure 364. Stamp solenoid 430 Figure 365. Spring 431 Figure 366. Placing the spring in the temporary position on the retaining hook 431 Figure 367. Detaching the solenoid 432 Figure 368. Detaching the side plate 432 Figure 369. Delivery unit linking plate 433 Figure 370. Removing the feeding belt 433 Figure 371. External covers 434 Figure 372. Rear cover 434 Figure 373. Upper left cover and screws 435 Figure 374. Front cover and screws 435 Figure 375. Rear cover and screws 436 Figure 376. Upper right cover and screws 436 Figure 377. Paper-size limit panel 437 Figure 378. Fixing plate and limit panel 438 Figure 379. Connectors and cable clamps 439 Figure 380. Pick-up unit 439 Figure 381. Pick-up roller 440 Figure 382. Feed roller and separation roller 441 Figure 383. Preparing to remove the lifter wire 442 Figure 384. E-ring and pulley cover 442 Figure 385. Pulley cover 443 Figure 386. Screw and lifter wire 444 Figure 387. Parts removal behind the lifter wire 445 Figure 388. Connectors 446 Figure 389. Paper-detection unit 446 Figure 390. Lifter drive unit 447 Figure 391. Rear panel 447 Figure 392. E-ring and gear 448 Figure 393. E-ring and pulley cover 448 Figure 394. Bracket removal 449 Figure 395. Lifter wire removal 450 Figure 396. Tightening the lifter wire 451 Figure 397. Lifter motor (M1 452 Figure 398. Feeder motor (M2 452 Figure 399. Pick-up motor (M3 453 Figure 400. Deck controller PCB 453 Figure 401. Power supply PCB 454 Figure 402. Standard image sample 464 14 Figures EN