HP 9050 HP LaserJet MFP Multifunction Finisher - Administrator Guide - Page 32

Control-panel messages The following table explains device messages that might appear on the control panel. Table 3-2 Control-panel messages Control panel message Description Recommended action CLOSE FRONT DOOR ON LEFT ACCESSORY CLOSE TOP COVER ON LEFT ACCESSORY DIFFERENT PAPER SIZES IN JOB FINISHING UNAVAILABLE INSTALL BOOKLET BIN INSTALL STAPLER UNIT OPTIONAL BIN 01 FULL OPTIONAL BIN 02 FULL OUTPUT PAPER PATH OPEN STAPLE AREA SAFETY PROTECTION ACTIVATED STAPLER LOW ON STAPLES STAPLER OUT OF STAPLES TOO MANY PAGES IN JOB TO STAPLE TOO MANY PAGES TO MAKE BOOKLET 13.12.11 - JAM IN STAPLER 13.12.21 - JAM IN LEFT ACCESSORY 13.12.22 - JAM IN LEFT ACCESSORY 13.12.23 - JAM IN LEFT ACCESSORY 13.12.31 - JAM IN LEFT ACCESSORY 13.12.32 - JAM IN LEFT ACCESSORY The stapler door is open or is not closed correctly. The door is open or is not properly closed. Close the stapler door correctly. Close the top door. Different paper sizes are used for a single job. Verify that all pages in the job are configured for the same size of paper. A failure has occurred with the finishing process. Remove all media from the bins. If the error message reappears, record the message and call for support. The booklet bin is not correctly installed. Verify that the booklet bin is correctly installed. The stapler unit is not correctly installed. Verify that the stapler unit is correctly installed. The stacker bin is full. Remove all media from the stacker bin. The booklet bin is full. Remove all paper from the booklet bin. The accessory on the left side is not correctly Verify that the accessory is correctly attached. attached. A staple safety alert has occurred. Remove any obstruction from the stacker bin ejection area. The stapler cartridge has 20 to 50 staples remaining. Replace the staple cartridge if you want to saddle stitch more than 10 sets in a job. The stapler cartridge contains no more staples. Replace the stapler cartridge. See Load the stapler cartridge on page 17 The job height is greater than the stapler Verify that the job is within specifications to capacity. The height of the job to be stapled be stapled. See Supported media should not exceed 50 sheets of 20-lb bond. on page 39 The page content is too large to be saddle stitched. Verify that the job is within specifications to be saddle stitched. A staple jam has occurred. Check for a jammed staple in the staple cartridge. A paper jam exists in the flipper assembly. Check for jammed media in the output area of the printer or the input area of the device. A paper jam exists in the paper-path area. Check for jammed media in the output area of the printer or the input area of the device. 13.12.33 - JAM IN LEFT ACCESSORY 13.12.34 - JAM IN LEFT ACCESSORY 26 Chapter 3 Problem solving ENWW