HP AM866A Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 20 - Page 164
FABS-1005, Message, Probable Cause, Recommended, Action, firmwareDownload, Severity
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
16 FABS-1005 FABS-1005 Message , [FABS-1005], ,, WARNING, , (= ) Probable Cause Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS problem or file corruption. The possible values for function name and description of problem are: fabsys_write: Unsupported write operation: process xxx where "xxx" is the process ID (PID), which could be any whole number. Recommended Action Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems). If the message persists, run the firmwareDownload command to update the firmware. Severity WARNING FABS-1006 Message , [FABS-1006], ,, WARNING, , : object unit Probable Cause Indicates that there is no device in the slot with the specified object type ID in the system module record. This could indicate that a serious Fabric OS data problem on the switch. The possible values for function name and description of problem are: • setSoftState: bad object • setSoftState: invalid type or unit • media_sync: Media oid mapping failed • fabsys_media_i2c_op: Media oid mapping failed • fabsys_media_i2c_op: obj is not media type • media_class_hndlr: failed sending media state to blade driver Recommended Action If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the fabric failed, fail over or reboot the switch. If the message persists, run the firmwareDownload command to update the firmware. Severity WARNING FABS-1007 Message , [FABS-1007], ,, WARNING, , : Media state is invalid - status= Probable Cause Indicates that the Fabric OS has detected an invalid value in an object's status field. This is usually an internal Fabric OS problem or file corruption. Recommended Action Reboot or power cycle the switch. If the message persists, run the firmwareDownload command to update the firmware. 112 Fabric OS Message Reference 53-1000600-02