HP AM866A Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 20 - Page 192
FCR-1056, configuration parameters such as Operating Mode, E_D_TOV, Domain ID Offset, etc.
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
22 FCR-1056 Severity INFO FCR-1056 Message , [FCR-1056], ,, INFO, , Switch with front domain ID does not support backbone to edge imports. Probable Cause Indicates that a switch that does not support backbone-to-edge routing is running in the MetaSAN. Recommended No action is required if backbone-to-edge routing is not needed. Otherwise replace the switch with Action one that supports backbone to edge routing. Severity INFO FCR-1057 Message , [FCR-1057], ,, ERROR, , EX_Port() incompatible long distance parameters on link. Probable Cause Indicates that the port, which is configured in long distance mode, has incompatible long distance parameters. Recommended Action Check the port configuration on both sides of the link using the portCfgShow command. Investigate the other switch for more details. Run the errShow command on the other switch to view the error log for additional messages. Severity ERROR FCR-1058 Message , [FCR-1058], ,, WARNING, , Port isolated due to mismatched configuration parameter; . Probable Cause Indicates that the specified port was isolated after segmentation caused by mismatched configuration parameters or by domain ID assigned by the principal switch that did not match the insistent domain ID of this port. Recommended Action Please check the switches on both ends of the link for a possible mismatch in switch or port configuration parameters such as Operating Mode, E_D_TOV, R_A_TOV, Domain ID Offset, etc. Run the portCfgExport command to modify the appropriate parameters on the local switch. Run the appropriate configuration command to modify the switch or port parameters on the remote switch. Severity WARNING 140 Fabric OS Message Reference 53-1000600-02