HP AM866A Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 20 - Page 60
Reading a RAS System Message - firmware
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
1 Reading a RAS System Message 2. Verify the configuration: switch:admin> auditcfg --show Audit filter is enabled. 1-ZONE 2-SECURITY 3-CONFIGURATION 4-FIRMWARE 5-FABRIC 3. Enable the audit feature: switch:admin> auditcfg --enable Audit filter is enabled. 4. Configure up to six syslog servers to receive the audit events that will be generated through syslog (procedure will vary depending on server type). 5. Configure syslog on the switch to point to the configured servers' IP addresses. switch:admin> syslogdipadd 10.128.128.160 6. Verify the switch's syslog configuration: switch:admin> syslogdipshow syslog.1 192.168.163.234 syslog.2 10.128.128.160 Reading a RAS System Message This section provides information about reading system messages. The following example shows the format of the RAS system error message: , [], , ,,, The following example shows a sample message from the error log: 2004/07/22-10:12:33, [EM-1031], 4,, ERROR, switchname, Slot 7 ejector not closed The fields in the error message are described in Table 3.: TABLE 3 System Message Field Description Example Variable Name Description 2004/07/22-10:12:33 Date and Time Stamp [EM-1031] Message Module and Message Number The system time (UTC) when the message was generated on the switch. The RASLog subsystem supports an internationalized timestamp format base on the "LOCAL" setting. The message module and number. These values uniquely identify each message in the Fabric OS and reference the cause and actions recommended in this manual. Note that not all message numbers are used; there can be gaps in the numeric message sequence. 8 Fabric OS Message Reference 53-1000600-02