HP BL480c HP BladeSystem Onboard Administrator Command Line Interface User Gui - Page 11
Signal direction, Description, Parameter, Value, Enter., When prompted, enter a valid user name
![]() |
UPC - 882780759664
View all HP BL480c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Pin Name 3 TXD 4 DTR 5 GND 6 DSR 7 RTS 8 CTS 9 RI Signal direction -->> -->> Description Transmit data Data terminal ready System ground Data set ready Request to send Clear to send Ring indicator 2. Use any standard communication software to launch a terminal emulation session with the following parameters: Parameter Transmission rate Data bits Parity Stop bits Protocol Value 9600 bps 8 None 1 None 3. When prompted, enter a valid user name, and then press Enter. 4. Enter a valid password, and press Enter. The CLI command prompt appears. 5. Enter commands for the Onboard Administrator. 6. To terminate the terminal session, enter Exit at the prompt. Accessing the command line interface 11
![](/manual_guide/products/hewlettpackard-bl480c-hp-bladesystem-onboard-administrator-command-line-interface-user-guide-version-300-b350cfc/11.png)
Accessing the command line interface
11
Pin
Name
Signal direction
Description
3
TXD
-->>
Transmit data
4
DTR
-->>
Data terminal ready
5
GND
System ground
6
DSR
<<--
Data set ready
7
RTS
-->>
Request to send
8
CTS
<<--
Clear to send
9
RI
<<--
Ring indicator
2.
Use any standard communication software to launch a terminal emulation session with the following
parameters:
Parameter
Value
Transmission rate
9600 bps
Data bits
8
Parity
None
Stop bits
1
Protocol
None
3.
When prompted, enter a valid user name, and then press
Enter.
4.
Enter a valid password, and press
Enter.
The CLI command prompt appears.
5.
Enter commands for the Onboard Administrator.
6.
To terminate the terminal session, enter
Exit
at the prompt.