HP BladeSystem bc2000 Setup and Installation Guide HP BladeSystem bc2000 and b - Page 79
Blade PC Diagnostic Steps, Table D-9
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Blade PC Diagnostic Steps If your blade PC does not start, or powers up but does not complete POST, answer the questions in Table D-9 to determine appropriate actions based on the symptoms observed. According to the answers you give, you are directed to the appropriate table in the section that immediately follows. That table outlines possible reasons for the problem, options available to assist in diagnosis, and possible solutions. Table D-9 Blade PC Diagnostic Steps Question Question 1: Is the power LED on the blade PC green? Action If yes, continue to Question 2 of this table. Question 2: Is the health LED on the blade PC green? Question 3: Is the NIC A or NIC B LED on the blade PC illuminated? Question 4: Is the monitor displaying information when connected to the blade PC through the diagnostic adapter? If no, see Table D-10 Is the Blade PC Health LED Green? on page 71 If yes, continue to Question 3 of this table. If no, see Table D-11 Is the Health LED on the Blade PC Green? on page 72 If yes, continue to Question 4 of this table. If no, see Table D-12 Is the NIC A or NIC B LED on the Blade PC Illuminated? on page 74 If yes, use the POST messages for further diagnosis, or continue to Table D-14 Problems After Initial Boot on page 76. If no, see Table D-13 Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic Adapter? on page 74 Table D-10 Is the Blade PC Health LED Green? Answer Possible Reasons Possible Solutions No, it is off. Blade PC is not seated properly. Either the blade PC or the blade PC bay is not functioning properly. Determine whether the problem lies with the blade PC or with the enclosure: ● Remove the blade PC from the enclosure, and insert it into a different bay. If the power LED on the blade PC comes on and turns green, the problem lies with the original bay. ● If the power LED on the blade PC does not come on, try placing a different blade PC in the original bay. If the power LED on the new blade PC comes on, the old blade PC may have failed. ● Contact HP or your authorized service provider for replacement parts and service. ENWW Blade PC Diagnostic Steps 71