HP BladeSystem bc2000 Setup and Installation Guide HP BladeSystem bc2000 and b - Page 82
Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Table D-11 Is the Health LED on the Blade PC Green? (continued) No, it blinks red eight times, once per The blade PC has failed to communicate ● second, followed by a two second pause. with the enclosure during the POST boot cycle. ● ● Remove the blade PC and reinsert it in the enclosure. Move the blade PC to a different bay to see if it may be an enclosure connector issue. Try another enclosure and see if the enclosure health LED is green. ● Replace the blade PC. No, it blinks red nine times, once per second, followed by a two second pause. NIC A or NIC B has failed. Replace the blade PC. Yes it is green. If the health LED on the blade PC is green, go to Table D-12 Is the NIC A or NIC B LED on the Blade PC Illuminated? on page 74. Table D-12 Is the NIC A or NIC B LED on the Blade PC Illuminated? Answer Possible Reasons Possible Solutions No. The NIC is not connected to an active Connect the NIC to an active network network connector. connector. Go to Table D-13 Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic Adapter? on page 74 Yes, it is blinking green. The connector is working normally, the link is active, and data is being transferred. Go to Table D-13 Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic Adapter? on page 74. Yes, it is green. The connector is working normally, and the link is active. Go to Table D-13 Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic Adapter? on page 74. Table D-13 Is the Monitor Displaying Information When Connected to the Blade PC Through the Diagnostic Adapter? Answer Possible Reasons Possible Solutions 74 Appendix D Troubleshooting ENWW