HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 280

2 fcipChipTest fcipChipTest Synopsis Tests functionality of components in the FCIP complex. fcipchiptest [--slot slot][-testtype type][-unit number] Description Use this command to verify the internal registers and memory of the network processor, FCIP FPGA, compression processor, and GigPHY. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms. Operands This command has the following operands: --slot slot Specifies the slot number on which the diagnostic operates. The default is 0 and operates on fixed-port-count products. -testtype type Specifies the test type to run. By default, the command runs all tests. Valid tests include: 0 All tests 1 Network processor SRAM test 2 FCIP FPGA internal register test 3 FCIP FPGA interrupt test 4 FCIP FPGA checksum test 5 -unit number Compression engine MBIST and LBIST Specifies the GbE port to test. By default, all GbE ports in the specified slot are used. Valid number values include: 0 GbE port 0 1 GbE port 1 2 All GbE ports Examples To run all tests on slot 7 and GbE port 1: switch:admin> fcipchiptest --slot 7 -unit 1 -testtype 0 Running fcipchiptest Test Complete: fcipchiptest Pass 1 of 1 Duration 0 hr, 1 min & 15 sec (0:1:15:351). passed. 248 Fabric OS Command Reference 53-1001764-01