HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 836

2 portThConfig For more information on port threshold configuration procedures, including default values for specific area high/low thresholds, refer to the Fabric Watch Administrator's Guide. Operands This command has the following operands: port_type Specifies the port type for which to configure or display Fabric Watch settings. This operand is optional with the --show option. With all configuration options it is required. Valid port types include one of the following: e-port Configures or displays all E_Ports (not supported in Access Gateway mode). fop-port Configures or displays all optical F_Ports. fcu-port Configures or displays all copper F_Ports. This operand is supported only on embedded platforms and only on copper ports. port Configures or displays all physical ports. ve-port -area area Configures or displays all VE_Ports. Only a subset of areas can be configured for this port type (not supported in Access Gateway mode). Specifies the area monitored by the Fabric Watch daemon. This operand is optional with the --show option. With all configuration options it is required The following areas are valid when configuring or displaying configuration settings on E_Ports, optical F_Ports, copper F_Ports, and physical ports. Area values are not case-sensitive. CRC Cyclic redundancy check error ITW Invalid transmission word C3TX_TO Class 3 transmit frames discarded due to timeout. LOS Loss of synchronization LF Link failure RX Receive error TX Transmit error PE Protocol error LR Link reset ST State change TU Trunk Utilization Only the following areas are valid for VE_Ports. UTIL Port utilization PKTLOSS Packet loss ST State change --set Configures the Fabric Watch thresholds for monitoring a specified area for all ports of a specified port type. When configuring a threshold, you must specify a port type and area. The following operands are optional and valid only with the --set option. Defaults are used unless you configure custom settings. Defaults parameters vary depending on the area and platform. Refer to the Fabric Watch Administrator's Guide for specific details. 804 Fabric OS Command Reference 53-1001764-01