HP CE863A User Manual - Page 44
Network Setup menu
View all HP CE863A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Network Setup menu In the following table, items that have an asterisk (*) indicate the factory default setting. Menu item Sub-menu item Sub-menu item Description Wireless Menu Wireless Direct Settings Wireless Direct On/Off NOTE: You can also access this menu by touching the Wireless button on the control panel. Wireless Direct Name Wireless Direct Mode Enables or disables the Direct Wi-Fi wireless access feature. Set the product's Direct Wifi name, so you can access it from other wireless devices that support the Wi-Fi Direct protocol. Set the product's Direct Wifi mode. ● Select the Print Only option (the default setting) to allow wireless access to only the product print functions from a mobile device. ● Select the Open Network option to allow wireless access to all product functions and settings from a mobile device. Wireless Setup Wizard Guides you through the steps to set up the product on a wireless network Wi-Fi Protected Setup If your wireless router supports this feature, use this method to set up the product on a wireless network. This is the simplest method. Run Network Test Tests the wireless network and prints a report with the results. Turn Wireless On/Off Enables or disables the wireless network feature. TCP/IP Config Automatic* Manual Automatic: The product automatically configures all the TCP/IP settings via DHCP, BootP or AutoIP. Manual: You can manually configure the IP address, subnet mask, and default gateway. The control panel prompts you to specify values for each address section. As each address is completed, the product prompts for address confirmation before moving to the next one. After all three addresses are set, the network reinitializes. Auto Crossover On* Off Enables or disables the use of a standard 10/100 network cable when the product is directly connected to a computer. Network Services IPv4 IPv6 Enable or disable the IPv4 and IPv6 protocols. By default, each protocol is enabled. Link Speed Automatic* Sets the link speed manually if needed. 10T Full 10T Half After setting the link speed, the product automatically restarts. 100TX Full 100TX Half 28 Chapter 2 Control panel menus ENWW