HP CP3525n HP Color LaserJet CP3525 Series Printers - User Guide - Page 188
Control panel message, Description, Recommended action, CAUTION, INSTALL <COLOR> CARTRIDGE - fuser replacement
UPC - 883585892327
View all HP CP3525n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Table 11-1 Control-panel messages (continued) Control panel message Description Recommended action INCOMPATIBLE FUSER The incorrect fuser was installed. CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before handling it. 1. Open the right door. 2. Remove the incompatible fuser. 3. Install the correct fuser. 4. Close the right door. INCOMPATIBLE SUPPLIES Print cartridges or other supply items are installed that were not designed for this product. The product cannot print with these supplies installed. Install supplies that are designed for this product. Incorrect The PIN is incorrect. Use the up arrow and down arrow buttons to enter the correct PIN. Initializing The product is starting. No action is necessary. Please wait until the Ready message appears on the display. Initializing permanent storage Displayed when the product is turned on to show that permanent storage is being initialized. No action is necessary. Insert or close tray The indicated tray is open, and it is interfering Close the tray so that printing can continue. with paper being fed from another tray. INSTALL CARTRIDGE The print cartridge has been removed or has Replace or reinstall the print cartridge been installed incorrectly. correctly to continue printing. See Change print cartridges on page 143. INSTALL FUSER The fuser has been removed or installed incorrectly. CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before handling it. 1. Open the right door. 2. Install or adjust the fuser. 3. Close the right door. INSTALL SUPPLIES For status press OK Press the OK button to identify which supplies need to be replaced. Press the OK button a second time for more information about the specific supply. Insert the supply item or make sure the installed supply item is fully seated. INSUFFICIENT MEMORY TO LOAD FONTSDATA The product does not have enough memory To continue without this information press the to load the data (for example, fonts or OK button . If the message persists, add more macros) from the location specified. memory. LOAD TRAY 1 [TYPE] [SIZE] To continue press OK The indicated tray is loaded and configured 1. If the correct paper is loaded, press the for a type and size other than the one OK button. specified in the job. 2. Otherwise, remove the incorrect paper and load the tray with the specified paper. 3. If prompted, confirm the size and type of paper loaded. 176 Chapter 11 Solve problems ENWW