HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 1

Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(37)SE and Later Revised August 8, 2007 Cisco IOS Release 12.2(37)SE and later runs on the Cisco Catalyst Blade Switch 3020 for HP, also referred to as the switch. These release notes include important information about Cisco IOS Release 12.2(37)SE and later and any limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for your switch: • If you are installing a new switch, see the Cisco IOS release label on the rear panel of your switch. • If your switch is on, use the show version privileged EXEC command. See the "Finding the Software Version and Feature Set" section on page 4. • If you are upgrading to a new release, see the software upgrade filename for the software version. See the "Deciding Which Files to Use" section on page 4. For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the "Related Documentation" section on page 22. You can download the switch software from this site (registered Cisco.com users with a login password): http://www.cisco.com/kobayashi/sw-center/sw-lan.shtml This software release is part of a special release of Cisco IOS software that is not released on the same 8-week maintenance cycle that is used for other platforms. As maintenance releases and future software releases become available, they will be posted to Cisco.com in the Cisco IOS software area. Contents This information is in the release notes: • "System Requirements" section on page 2 • "Upgrading the Switch Software" section on page 3 • "Installation Notes" section on page 6 Americas Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA © Cisco Systems, Inc. All rights reserved.