HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 11
VLAN, Device Manager Limitations, Important Notes, Cisco IOS Notes
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Important Notes VLAN • For trunk ports or access ports configured with IEEE 802.1Q tagging, inconsistent statistics might appear in the show interfaces counters privileged EXEC command output. Valid IEEE 802.1Q frames of 64 to 66 bytes are correctly forwarded even though the port LED blinks amber, and the frames are not counted on the interface statistics. There is no workaround. (CSCec35100). This is the VLAN limitation: • If the number of VLANs times the number of trunk ports exceeds the recommended limit of 13,000, the switch can fail. The workaround is to reduce the number of VLANs or trunks. (CSCeb31087) Device Manager Limitations These are the Device Manager limitations for this release: • When you are prompted to accept the security certificate and you click No, you only see a blank screen, and the device manager does not launch. The workaround is to click Yes when you are prompted to accept the certificate. (CSCef45718) • When the physical UID LED of the switch is on, it is blue. However, when the image of this LED on the device manager Front Panel view is on, it is green. There is no workaround (CSCsd98457). Important Notes These sections describe the important notes related to this software release: • "Cisco IOS Notes" section on page 11 • "Device Manager Notes" section on page 12 Cisco IOS Notes These notes apply to Cisco IOS software: • The behavior of the no logging on global configuration command changed in Cisco IOS Release 12.2(18)SE and later. You can only use the logging on and then the no logging console global configuration commands to disable logging to the console. (CSCec71490) • In Cisco IOS Release 12.2(25)SEC, the implementation for multiple spanning tree (MST) changed from the previous release. Multiple STP (MSTP) complies with the IEEE 802.1s standard. Previous MSTP implementations were based on a draft of the IEEE 802.1s standard. • If the switch requests information from the Cisco Secure Access Control Server (ACS) and the message exchange times out because the server does not respond, a message similar to this appears: 00:02:57: %RADIUS-4-RADIUS_DEAD: RADIUS server 172.20.246.206:1645,1646 is not responding. If this message appears, check that there is network connectivity between the switch and the ACS. You should also check that the switch has been properly configured as an AAA client on the ACS. OL-12577-03 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(37)SE and Later 11