HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 14

Resolved Caveats - ping from the switch to the connected device • CSCua54137 When the switch reverts from a floating static route to a static route, packets are lost. The workaround is to set static ARP. • CSCua74302 (Switches running the LAN base image) ACLs applied to outbound traffic on the switch virtual interface (SVI) do not work. There is no workaround. • CSCud21309 The Address Resolution Protocol (ARP) packets leak in the isolated ports of a private VLAN when dot1x is enabled. There is no known workaround. Resolved Caveats • Caveats Resolved in Cisco IOS Release 15.0(2)SE5, page 14 • Caveats Resolved in Cisco IOS Release 15.0(2)SE4, page 15 • Caveats Resolved in Cisco IOS Release 15.0(2)SE3, page 15 • Caveats Resolved in Cisco IOS Release 15.0(2)SE1, page 16 • Caveats Resolved in Cisco IOS Release 15.0(2)SE, page 18 Caveats Resolved in Cisco IOS Release 15.0(2)SE5 • CSCua00661 A memory leak is observed when configuring VLANs using tclsh mode. The workaround is to make the tclsh mode interactive to avoid any memory leak. • CSCue94252 When the privilege exec level 5 show mac address-table interface gigabitethernet privileged EXEC command is entered, all interfaces in the switch have the command applied to the running configuration. There is no workaround. • CSCug26848 CPU usage goes above 90% when Internet Group Management Protocol (IGMP) version 3 report packets are sent to the switch which has IGMP version 2 configured on the switch virtual interface. The workaround is to either disable multicast fast convergence or configure IGMP version 3 on switch virtual interface. • CSCug51225 Topology Change Notification (TCN) occurs over the network when a new stack member is added to the switch stack. There is no workaround • CSCug52714 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 15.0(2)SE and Later 14 OL-27324-02