HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 15

Resolved Caveats TACACS+ single connect authentication request from a switch stack takes around 10 to 12 minutes to failover to secondary server after the primary TACACS server is unreachable. The workaround is to disable TACACS+ single connect configuration on the switch. • CSCuh75095 After rebooting a Cisco Catalyst Blade Switch 3012 (CBS3012), incorrect data is found in the vital product data (VPD) of the switch, which causes the switch to become unmanageable. There is no workaround. • CSCui41032 Switch runs out of memory within few seconds of configuring the command privilege exec level show spanning-tree active/detail. There is no workaround. Caveats Resolved in Cisco IOS Release 15.0(2)SE4 • CSCuf77683 Internal VLANs are displayed when the show snmp mib ifmib ifindex command is entered or the SNMP is queried for the ipMIB object. The workaround is to check if the displayed VLANs are internal and then to hide them. • CSCug62154 When the switch is started using TACACS+ configurations, the CPU utilization increases to 100% and the VTY device does not work. The workaround is to remove the TACACS+ configurations and restart the switch. • CSCuh41077 The ipAddrEntry value in the IP Address Table shows an interface index that is not exposed by the ifEntry Object ID. There is no workaround. Caveats Resolved in Cisco IOS Release 15.0(2)SE3 • CSCta43825 CPU usage is high when an SNMP Walk of the Address Resolution Protocol (ARP) table is performed. The workaround is to implement SNMP view using the following commands: snmp-server view cutdown iso included snmp-server view cutdown at excluded snmp-server view cutdown ip.22 excluded snmp-server community public view cutdown ro snmp-server community private view cutdown rw OL-27324-02 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 15.0(2)SE and Later 15