HP Dc5850 Broadcom NetXtreme Gigabit Ethernet Plus NIC - Page 11

Setting Up Initial Administrator Account for DASH - driver

Get HP Dc5850 - Compaq Business Desktop PDF manuals and user guides
UPC - 884962022993
View all HP Dc5850 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Figure 8 Enabling DASH ASF Enabling ASF can be enabled with the Broadcom Advanced Control Suite (BACS). Steps 1 - 5 are the same as enabling DASH, but there are a few additional steps. 1 - 5) Same as enabling DASH (see above). 6) Set Management Console Address. 7) Set SNMP Connectivity Name. In addition, make sure the Secure RMCP Support for ASF 2.0 is enabled. Setting Up Initial Administrator Account for DASH Setting up an Administrator account for DASH requires the use of the Broadcom NetXtreme Gigabit Drivers for Multiple Operating Systems Softpaq. This is available at www.hp.com. Execute the Softpaq, and then open a Command box as Administrator. Use the following steps to create an Administrator account: 1. Go to the directory where the Broadcom application is installed. 2. Run bmcc edit. This will execute the Broadcom Manageability Configuration and Control applica- tion and will bring up a list of Management Firmware Configuration options. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
11
Figure 8
Enabling DASH
ASF Enabling
ASF can be enabled with the Broadcom Advanced Control Suite (BACS). Steps 1 - 5 are the same as
enabling DASH, but there are a few additional steps.
1 - 5) Same as enabling DASH (see above).
6) Set
Management Console Address
.
7) Set
SNMP Connectivity Name
.
In addition, make sure the Secure RMCP Support for ASF 2.0 is enabled.
Setting Up Initial Administrator Account for DASH
Setting up an Administrator account for DASH requires the use of the Broadcom NetXtreme Gigabit Driv-
ers for Multiple Operating Systems Softpaq. This is available at
www.hp.com
.
Execute the Softpaq, and then open a Command box as Administrator.
Use the following steps to create an Administrator account:
1.
Go to the directory where the Broadcom application is installed.
2.
Run
bmcc edit
. This will execute the Broadcom Manageability Configuration and Control applica-
tion and will bring up a list of Management Firmware Configuration options.