HP Designjet 10000s HP Designjet 8000s, 9000s, and 10000s Air Purifier System - Page 21

5 Troubleshooting Fault No suction output (fumes/gases are not being extracted). Cause Suction hose not connected to the APS. Suction hose not connected to the machine Damage to the suction hose. Suction hose is connected to the wrong machine. Suction hose is connected to the wrong point of entry (opening) of the machine. Suction channel blocked. Clean gas channel blocked. Suction output too low (fumes/gases are hardly being extracted). Filter elements full. Damage to the suction hose. Suction hose not correctly connected to the APS. Suction hose not correctly connected to the machine. Air outlet blocked. Suction hose is connected to the wrong point of entry (opening) on the machine. Fault on the APS. Correction Connect suction hose to the APS. Connect suction hose to the printer. Replace suction hose. Connect suction hose to the correct machine. Connect suction hose to the right point of entry (opening) of the machine. Check suction channel, if necessary correct error found. Check clean gas channel, if necessary correct error found. Replace filter package, dispose of old filter properly! Replace suction hose. Check fitting of the suction hose to the APS, if applicable reinsert into suction opening. Check fitting of the suction hose to the machine if necessary reconnect. Check air outlet status,and clean blocke holes. Connect suction hose to the right point of entry (opening) on the machine. Contact your HP Service representative. APS is not running. Plug connection power supply not or wrongly plugged in. No power on the socket. Fault on the APS. Check/correctly plug in plug connection power supply. Check power supply, if necessary correct error. Contact your HP Service representative. HP Air Purifier System 21