HP EK430AA User's Guide - HP Plasma HDTV - Page 27
Turning On the TV, Turning the TV On and Off (Standby)
View all HP EK430AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Turning On the TV Turning On the TV Turning the TV On and Off (Standby) The TV has a Power button (A) on the front of the display. You can also use the remote control Power button to turn on the TV. Pressing the Power button either turns the TV on or places it into standby, which is a reduced power state. MENU OK n The initial setup starts when the TV powers on for the first time. If the TV has been turned on before, the Setup Wizard does not start. See "Starting the Setup Wizard" on page 40 to start the Setup Wizard from the System menu. + VOL - + CH AB - SRC A Power button and light B Remote control sensor The Power button includes an indicator light, which shows the power status of the TV. Power indicator Lights red Lights blue Off Power status Standby (off) Ready (on) AC power disconnected After the initial setup, the power-up time from standby depends on the Standby Mode setting: ■ Low power, which consumes less power while in standby, uses approximately 20 seconds of power-up time. ■ Fast power, which consumes more power while in standby, uses approximately 5 seconds of powerup time. You can set the Standby Mode by using the System menu. If the TV is not used for an extended period of time, press the Power button to place the TV into standby, and then unplug the power cord. Using the TV buttons 1 Press the Power button (A) on the front of the TV. The TV is on or in standby. 2 Press SRC button to open the list of input sources. Press CH+ to select the input source to view, and press OK. Press SRC to close the list. Flashing red or flashing blue Start up diagnostics or error Turning On the TV 17