HP ENVY m6-ar000 Maintenance and Service Guide - Page 46
Connector board, Detach the connector board cable
View all HP ENVY m6-ar000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Connector board NOTE: The connector board spare part kit does not include the connector board cable. The connector board cable is available using spare part number 856801-001. Description Connector board (includes audio jack and USB port) Spare part number 856792-001 Before removing the connector board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 24). 5. Disconnect the battery cable from the system board (see Battery on page 26). 6. Remove the fan/heat sink assembly (see Fan/heat sink assembly on page 35). Remove the connector board: 1. Release the ZIF connector (1) to which the connector board cable is connected, and then disconnect the connector board cable from the system board. 2. Detach the connector board cable (2) from the keyboard/top cover. (The connector board cable is attached to the keyboard/top cover with double-sided adhesive.) 3. Remove the two Phillips PM2.0×4.6 screws (3) and the Phillips PM2.0×3.3 screw (4) that secure the connector board to the keyboard/top cover. 4. Remove the connector board (5). 38 Chapter 5 Removal and replacement procedures