HP ENVY m6-n000 ENVY m6 Notebook PC ENVY Notebook PC Maintenance and Service G - Page 72
Connector board, Release the connector board cable from the retention clips built into the top cover
View all HP ENVY m6-n000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Connector board NOTE: The connector board spare part kit includes the audio jack, RJ-45 jack, USB port, and 2 cables. Description For use only on computer models equipped with a graphics subsystem with discrete memory For use only on computer models equipped with a graphics subsystem with UMA memory Spare part number 765146-001 765145-001 Before removing the connector board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 34), and then remove the following components: a. Service cover (see WLAN module on page 35) b. Hard drive (see Hard drive on page 38) c. Base enclosure (see Base enclosure on page 45) Remove the connector board: 1. Disconnect the connector board cable (1) from the system board. 2. Release the connector board cable from the retention clips built into the top cover (2) and the subwoofer (3). 3. Release the ZIF connector (4) to which the connector board ribbon cable is attached, and then disconnect the connector board ribbon cable from the system board. 4. Detach the connector board ribbon cable (5) from the base enclosure. (The connector board ribbon cable is attached to the top cover with double-sided tape.) 64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts