HP EliteDesk 800 G3 Hardware Reference Guide - Page 25
Disconnect the power and data cables from the rear of the drives in the hard drive cage.
View all HP EliteDesk 800 G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
11. To install a half-length expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis (1) so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board (2). NOTE: When installing an expansion card, press firmly on the card so that the whole connector is seated properly in the expansion card socket. 12. To install a full-length expansion card you must remove the hard drive cage to allow room for installing the card. a. Disconnect the power and data cables from the rear of the drives in the hard drive cage. b. Push the green drivelock mechanism on the hard drive cage away from the hard drive bays (1), lift the rear of the drive cage up (2), and then slide the drive cage back and lift it out of the chassis (3). Removing or installing an expansion card 19