HP EliteDesk 800 G3 Hardware Reference Guide - Page 40
Install four silver-and-blue 6-32 mounting screws two on each side of the drive.
![]() |
View all HP EliteDesk 800 G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
5. Remove the computer access panel. 6. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting screws. NOTE: Four extra 6-32 mounting screws for 3.5-inch hard drives are installed on the exterior of the hard drive bays. Refer to Removing and installing drives on page 23 for an illustration of the extra 6-32 mounting screws location. If you are replacing a drive, transfer the mounting screws from the old drive to the new drive. ● Install four silver-and-blue 6-32 mounting screws (two on each side of the drive). ● You can also install a 2.5-inch hard drive into a 3.5-inch drive bay using an adapter bracket similar to the example shown below. ◦ Slide the 2.5-inch drive into the 3.5-inch adapter bracket. 34 Chapter 2 Hardware upgrades
![](/manual_guide/products/hewlettpackard-elitedesk-800-g3-hardware-reference-guide-66945e1/40.png)