HP EliteDesk 800 Hardware Reference Guide - Page 79
board, if needed., Connect external cables to the installed card
View all HP EliteDesk 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
12. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis (1) so that the bracket on the card is aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion socket on the system board (2). NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 13. Rotate the slot cover retention latch back in place to secure the expansion card. 14. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 15. Replace the computer access panel. 16. If the computer was on a stand, replace the stand. 17. Reconnect the power cord and turn on the computer. ENWW Removing or installing an expansion card 71