HP Envy 13-1000 HP ENVY 13 - Maintenance and Service Guide - Page 46
by pulling it away from the slot at an angle., to prevent incorrect insertion of the WLAN module into
View all HP Envy 13-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Removal and replacement procedures Remove the WLAN module: Ä CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore computer functionality, and then contact technical support through Help and Support. 1. Disconnect the WLAN antenna cables 1 from the terminals on the WLAN module. ✎ The black WLAN antenna cable is connected to the WLAN module "Main" terminal. The white WLAN antenna cable is connected to the WLAN module "Aux" terminal. 2. Remove the two Phillips PM2.0×4.0 screws 2 that secure the WLAN module to the system board. (The WLAN module tilts up.) 3. Remove the WLAN module 3 by pulling it away from the slot at an angle. ✎ WLAN modules are designed with a notch 4 to prevent incorrect insertion of the WLAN module into the WLAN module slot. Reverse this procedure to install the WLAN module. Maintenance and Service Guide 4-17