HP Integrity BLc3000 HP 10GbE Pass-Thru Module User Guide - Page 10

Accessing the pass-thru module CLI

Get HP Integrity BLc3000 PDF manuals and user guides View all HP Integrity BLc3000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

4. Close the handle (2). Complete installation is indicated by a green Health LED. If the Health LED is amber or power is not applied to the module, see the HP BladeSystem Enclosure Setup and Installation Guide for troubleshooting information. Accessing the pass-thru module CLI You can access the pass-thru module CLI remotely using the Onboard Administrator enclosure or locally using the mini-USB to DB-9 RS232 Management serial port. Accessing the pass-thru module CLI remotely 1. Access the Onboard Administrator command line using telnet, SSH, or a serial connection. For more information on how to access the Onboard Administrator CLI, see the HP BladeSystem Onboard Administrator User Guide. 2. Use the connect interconnect command to access the module. For example, if the module is located in bay 2, enter the connect interconnect 2 command. To properly connect to the pass-thru module, you must disable flow control in the Onboard Administrator connect console. To disable flow control after you have connected to the module: 1. Press Enter. 2. Press Ctrl + _ (Ctrl + Shift + underscore) to access the Connect Utility menu. 3. Enter C to change the port settings. 4. Enter R to change settings for the remote port. 5. Enter N to disable flow control. After you have exited the menu, the pass-thru module CLI appears. NOTE: If the pass-thru module CLI does not appear, press Enter. Installing the pass-thru module 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
Installing the pass-thru module
10
4.
Close the handle (2).
Complete installation is indicated by a green Health LED. If the Health LED is amber or power is not
applied to the module, see the HP BladeSystem Enclosure Setup and Installation Guide for troubleshooting
information.
Accessing the pass-thru module CLI
You can access the pass-thru module CLI remotely using the Onboard Administrator enclosure or locally
using the mini-USB to DB-9 RS232 Management serial port.
Accessing the pass-thru module CLI remotely
1.
Access the Onboard Administrator command line using telnet, SSH, or a serial connection. For more
information on how to access the Onboard Administrator CLI, see the
HP BladeSystem Onboard
Administrator User Guide.
2.
Use the
connect interconnect <bay>
command to access the module. For example, if the
module is located in bay 2, enter the
connect interconnect 2
command.
To properly connect to the pass-thru module, you must disable flow control in the Onboard Administrator
connect console.
To disable flow control after you have connected to the module:
1.
Press
Enter.
2.
Press
Ctrl + _
(Ctrl + Shift + underscore) to access the Connect Utility menu.
3.
Enter
C
to change the port settings.
4.
Enter
R
to change settings for the remote port.
5.
Enter
N
to disable flow control.
After you have exited the menu, the pass-thru module CLI appears.
NOTE:
If the pass-thru module CLI does not appear, press
Enter.