HP Integrity BLc3000 HP 10GbE Pass-Thru Module User Guide - Page 12
Installing SFP+ transceivers
![]() |
View all HP Integrity BLc3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
• The system/info command displays image version, board revision, or chip revisions. • The effect from any CLI command is immediate. For example, configuring auto-negotiation on a port takes effect when the command is completed. • Flow control is not configurable because the pass-thru module cannot handle or generate pause packets. When using the 10GbE Pass-Thru Module, you must ensure that your pause configuration is correct for both link partners. Installing SFP+ transceivers CAUTION: Disconnect all cables before removing or installing an SFP+ transceiver, because of the potential damage to the cables, the cable connector, or the optical interfaces in the SFP+ transceiver. Removing and installing an SFP+ transceiver can shorten the life of the product. Do not remove and insert SFP+ transceivers more often than is necessary. CAUTION: HP recommends attaching an ESD-preventative wrist strap to your wrist and to a bare metal surface on the chassis to prevent electrostatic discharge. CAUTION: When not using the fiber-optic SFP+ transceiver and cable, be sure to install the dust plugs on both. The plugs and caps protect the SFP+ transceiver ports and cables from contamination and ambient light. 1. Remove the dust plug and save for future use. IMPORTANT: Use only HP-approved SFP+ transceivers. 2. Insert the SFP+ transceiver. With latch closed, be sure that the transceiver is fully seated and secure. CAUTION: If you plan to install the SFP+ transceiver into the bottom row of the module, before installation, rotate the SFP+ transceiver 180 degrees from the position shown in the illustration. Installing the pass-thru module 12
![](/manual_guide/products/hewlettpackard-bladesystem-c7000-hp-10gbe-passthru-module-user-guide-8e62fd5/12.png)