HP Integrity rx7620 Installation Guide, Seventh Edition - HP Integrity rx7620 - Page 51
Attaching a Caster to the Server
View all HP Integrity rx7620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Installing Additional Components Wheel Kit Installation 9. Locate and remove one of the four screws from the plastic pouch. Attach the a caster to the server. Figure 3-5 Attaching a Caster to the Server MWK005 3/12/03 10. Attach the remaining casters to the server using the screws supplied in the plastic pouch. 11. Remove the foam blocks from the left and right side of the server. 12. Locate the plywood ramp. 13. Attach the ramp to the edge of the pallet. NOTE There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to attach the ramp to the pallet. 14. Carefully roll the server off the pallet and down the ramp. 15. Locate the caster covers. Chapter 3 51
Chapter 3
Installing Additional Components
Wheel Kit Installation
51
9. Locate and remove one of the four screws from the plastic pouch. Attach the a caster to the server.
Figure 3-5
Attaching a Caster to the Server
10. Attach the remaining casters to the server using the screws supplied in the plastic pouch.
11. Remove the foam blocks from the left and right side of the server.
12. Locate the plywood ramp.
13. Attach the ramp to the edge of the pallet.
NOTE
There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to attach
the ramp to the pallet.
14. Carefully roll the server off the pallet and down the ramp.
15. Locate the caster covers.
MWK005
3/12/03