HP Jetdirect 640n HP Jetdirect Print Servers 640n and 695n - Administrator's G - Page 198
Link Speed, 10T Half, 10T Full, Print Protocols, protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC
View all HP Jetdirect 640n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued) Menu item Sub-menu item Sub-menu item Values and Description Link Speed Set the print server's link speed. The available settings depend on the device and installed print server. Select one of the following modes: Auto (default): Use auto-negotiation to configure the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 10T Half: 10 Mbps, half-duplex operation. 10T Full: 10 Mbps, full-duplex operation. 100TX Half: 100 Mbps, half-duplex operation. 100TX Full: 100 Mbps, full-duplex operation. 100TX Auto: Limits auto-negotiation to a maximum link speed of 100 Mbps on 1000T networks. 1000TX Full: 1000 Mbps, full-duplex operation. CAUTION: Changing the link setting can cause the loss of network communication with the print server. Print Protocols Print a page that lists the configuration of the following protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/ LLC. 188 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW