HP Kayak XA 05xx HP Kayak XA Series 05xx, Troubleshooting Your PC Workstation - Page 11

HP Kayak XA 05xx PC Workstation -Troubleshooting Your HP PC Workstation If Your PC Workstation Does Not Start Properly c Turn on the PC Workstation. This will erase the CMOS memory. d Wait until the PC Workstation has started. A message will be displayed similar to this: "Configuration has been cleared, set switch Clear CMOS to the Up/Off position before rebooting." e Turn off the PC Workstation, disconnect the power cable, and remove the cover. f Set the system board switch 6 (CLEAR CMOS) UP to retain the configuration. 2 Replace the cover and reconnect the power cables. 3 Switch on the PC Workstation. An error message will be displayed similar to the following: On your monitor: On your PC Workstation's LCD: Incorrect PC Configuration Error! POST 0012 The PC Workstation will stop. Press Enter (to view the system errors) and then press Esc. 4 Run Setup by pressing F2. CMOS default values will be automatically downloaded and saved. 5 Make any other changes you want and press Esc to save the configuration and exit from Setup. English 11