HP LA2405wg HP Compaq LA1905wg, LA2205wg, and LA2405wg LCD Monitors User Guide - Page 20

Removing the Monitor Pedestal Base - wall mount

Get HP LA2405wg - Widescreen LCD Monitor PDF manuals and user guides View all HP LA2405wg manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Removing the Monitor Pedestal Base You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture. CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect all USB cables connected to the monitor. 1. Disconnect and remove the signal, power, and USB cables from the monitor. 2. Lay the monitor face down on a flat surface covered by a clean, dry cloth. 3. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the monitor. Figure 3-9 Removing the Pedestal Base Screws 4. Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor stand from the slots in the monitor. Figure 3-10 Removing the Pedestal Base 12 Chapter 3 Setting Up the Monitor ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected. Also disconnect all USB cables connected to the
monitor.
1.
Disconnect and remove the signal, power, and USB cables from the monitor.
2.
Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3.
Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then pivot
the base 45 degrees counter-clockwise and remove the other screw from the back of the monitor.
Figure 3-9
Removing the Pedestal Base Screws
4.
Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor stand
from the slots in the monitor.
Figure 3-10
Removing the Pedestal Base
12
Chapter 3
Setting Up the Monitor
ENWW