HP LH4r HP Netserver LH 3 Pedestal-to-Rack Guide - Page 13
Removing Hard Disk Drives From the NetServer
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Chapter 2 Removing LH 3 Covers and Components 1. Refer to Figure 2-3 below. To unlock the drive, push the locking latch in and then pull the ejector handle toward you. 2. Gently pull the drive out about an inch to disengage the power connection. 3. Use your hand to support the bottom of the drive. Slowly pull the drive straight out. Do not allow the drive to fall. 4. Place the drive in an electrostatic protected container. Do not stack drives. Figure 2-3. Removing Hard Disk Drives From the NetServer 9
Chapter 2
Removing LH 3 Covers and Components
9
1.
Refer to Figure 2-3 below. To unlock the drive, push the locking latch in
and then pull the ejector handle toward you.
2.
Gently pull the drive out about an inch to disengage the power connection.
3.
Use your hand to support the bottom of the drive. Slowly pull the drive
straight out.
Do not allow the drive to fall
.
4.
Place the drive in an electrostatic protected container.
Do not stack drives.
Figure 2-3. Removing Hard Disk Drives From the NetServer