HP LH4r HP Netserver LH 3 Pedestal-to-Rack Guide - Page 21

Replacing the Power Supply Modules and Hard, Disk Drives

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Chapter 3 Installing LH 3r Components Figure 3-4. Reattaching the Control Panel Bezel Replacing the Power Supply Modules and Hard Disk Drives 1. Refer to Figure 2-4 and replace the power supply modules in the power supply cage. Make sure the modules are seated correctly and fasten the thumbscrews. 2. Refer to Figure 2-3 and replace the hard disk drive modules in the hot-swap mass storage cage. Make sure the locking pin engages the cage lip and secures the module in position. 3. Install the bezel for the HP rack version or the Compaq rack version. The installation is complete. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
Chapter 3
Installing LH 3r Components
17
Figure 3-4.
Reattaching the Control Panel Bezel
Replacing the Power Supply Modules and Hard
Disk Drives
1.
Refer to Figure 2-4 and replace the power supply modules in the power
supply cage. Make sure the modules are seated correctly and fasten the
thumbscrews.
2.
Refer to Figure 2-3 and replace the hard disk drive modules in the
hot-swap mass storage cage. Make sure the locking pin engages the cage
lip and secures the module in position.
3.
Install the bezel for the HP rack version or the Compaq rack version.
The
installation is complete.