HP LH4r HP Netserver LXr Pro8 - Page 17
antistatic mat.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 3 Perform the Upgrade Figure 3-6. Processor and Terminator Boards on the System Board 2. Using a Phillips head screwdriver, unscrew the two mounting screws that secure the terminator board in place. 3. Grasp the board you are removing, and lift firmly. Place it on the antistatic mat. 4. If you are installing more than one 200 MHz/1MB processor board, remove additional terminator boards as necessary. 13
Chapter 3
Perform the Upgrade
13
Figure 3-6.
Processor and Terminator Boards on the System Board
2.
Using a Phillips head screwdriver, unscrew the two mounting screws that
secure the terminator board in place.
3.
Grasp the board you are removing, and lift firmly. Place it on the
antistatic mat.
4.
If you are installing more than one 200 MHz/1MB processor board,
remove additional terminator boards as necessary.