HP LH4r HP Netserver LXr Pro8 Memory Board - Page 21
Hold the SDRAM DIMM so that the front edge faces straight down into
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Chapter 2 Installing Memory in the 4 GB Memory Board 4. Locate the slot where you will install the 128 SDRAM DIMM, and spread the two DIMM retaining clips outward. (Figure 2-12). Retaining Clip Retaining Clip Figure 2-12. Installing a DIMM Module 5. Align the notches on the SDRAM DIMM with the notches on the socket. 6. Hold the SDRAM DIMM so that the front edge faces straight down into the connector (at a 90° angle to the memory board). 17
Chapter 2
Installing Memory in the 4 GB Memory Board
17
4.
Locate the slot where you will install the 128 SDRAM DIMM, and spread
the two DIMM retaining clips outward. (Figure 2-12).
Retaining
Clip
Retaining
Clip
Figure 2-12. Installing a DIMM Module
5.
Align the notches on the SDRAM DIMM with the notches on the socket.
6.
Hold the SDRAM DIMM so that the front edge faces straight down into
the connector (at a 90
°
angle to the memory board).