HP LH4r HP Netserver LXr Pro8 Memory Board - Page 24

Memory, Board, Slots, Satellite, Chassis, Base Chassis, GB Memory Board, Retaining Clips

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Chapter 2 Installing Memory in the 4 GB Memory Board 3. Being careful not to touch board components, ease the first memory board into the top memory board slot and close the retaining latches on the front of the memory board to seat it snugly (Figure 2-13). Base Chassis Satellite Chassis Memory Board Slots Retaining Clips 4 GB Memory Board Figure 2-13. 4 GB Memory Board Installation 4. Install the second memory board in the lower slot. Verify that both memory boards are fully inserted into their respective system board connectors. 5. Reattach the rear access panel. a. Lower the panel into place. A slotted flange extends from the top of the panel on either side. Lower the slots over the matching tabs on the satellite chassis b. Tighten the captive screws. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
Chapter 2
Installing Memory in the 4 GB Memory Board
20
3.
Being careful not to touch board components, ease the first memory board
into the top memory board slot and close the retaining latches on the front
of the memory board to seat it snugly (Figure 2-13).
Memory
Board
Slots
Satellite
Chassis
Base Chassis
4 GB Memory Board
Retaining Clips
Figure 2-13. 4 GB Memory Board Installation
4.
Install the second memory board in the lower slot. Verify that both
memory boards are fully inserted into their respective system board
connectors.
5.
Reattach the rear access panel.
a.
Lower the panel into place. A slotted flange extends from the top of
the panel on either side. Lower the slots over the matching tabs on the
satellite chassis
b.
Tighten the captive screws.